The ring specs are 1.5mm, 1.75 (with the little "step") and 3mm for the oil control ring,
Pics of some of the action so far:
7A piston rings
7A piston rings
Doing a rebuild on my 7a "T" project, looking for OEM 82.5mm rings (053 198 151 or 054 197 151B), all i can find are single piston sets for $140ea!, that's $700 for all 5, I could buy JE pistons for a little more that that! Is there a cheaper alternative?
The ring specs are 1.5mm, 1.75 (with the little "step") and 3mm for the oil control ring,
Pics of some of the action so far:
The ring specs are 1.5mm, 1.75 (with the little "step") and 3mm for the oil control ring,
Pics of some of the action so far:
Re: 7A piston rings
I can do about half that on the rings, $70 per hole, hastings.
let me know.
let me know.
Marc Swanson
Proprietor, EFI Motorsport
Proprietor, EFI Motorsport
Re: 7A piston rings
Marc wrote:I can do about half that on the rings, $70 per hole, hastings.
let me know.
Thanks! I have 1 lead from Audifans on rings...
I am also interested in other items from your fine establishment:
20v fuel rail, stainless injector bungs, hardened crank timing gear, possibly coated bearings and even rods...?
Dan
-
90quattrocoupe
- Posts: 269
- Joined: Fri Mar 01, 2013 12:21 pm
- Location: Long Beach, CA.
Re: 7A piston rings
Dan, I think I have a 7a fuel rail you can have for the cost of shipping. I will check.
Greg W.
Greg W.
Re: 7A piston rings
90quattrocoupe wrote:Dan, I think I have a 7a fuel rail you can have for the cost of shipping. I will check.
Greg W.
I was going to say the same thing. I'm about to throw one in the junk pile.
"If you can't find one, make one"
Dallastown, PA
1991 Audi 80 quattro (20vt project)
1991 Audi Coupe Quattro (project: my first 20v)
2007 Mitsubishi Raider(Dakota in disguise)
2019 Chevy Cruze RS hatch (wife's little red sporty car)
Dallastown, PA
1991 Audi 80 quattro (20vt project)
1991 Audi Coupe Quattro (project: my first 20v)
2007 Mitsubishi Raider(Dakota in disguise)
2019 Chevy Cruze RS hatch (wife's little red sporty car)
Re: 7A piston rings
90quattrocoupe wrote:Dan, I think I have a 7a fuel rail you can have for the cost of shipping. I will check.
Greg W.
thanks!!
Re: 7A piston rings
DE80q wrote:90quattrocoupe wrote:Dan, I think I have a 7a fuel rail you can have for the cost of shipping. I will check.
Greg W.
I was going to say the same thing. I'm about to throw one in the junk pile.
thanks too!! I'll take either one!
Re: 7A piston rings
Got rings?? I noticed the second ring doesn't have the "step" in it like the OEM ring had....
