New V8

Document and share your build!
User avatar
yodasfro
Posts: 156
Joined: Fri Aug 02, 2013 11:50 am

Re: New V8

Post by yodasfro »

Oil pressure gauge is likely the ribbon connector in the cluster here's some info on that http://www.audifans.com/pipermail/v8/20 ... 03714.html . 4.2 clusters are suppose to be a little better made.
Austin 90' 90q 20v 91' 200 20v wagon 92' urs4
User avatar
scubagli
Posts: 604
Joined: Wed Feb 05, 2014 4:20 pm
Location: leeds ny

Re: New V8

Post by scubagli »

Thanks for the insight, I don't really want to dig into it, but I will have to at some point, as I get all sorts of phantom warning lights in the mfa...

Sent from my KFSOWI using Tapatalk
User avatar
scubagli
Posts: 604
Joined: Wed Feb 05, 2014 4:20 pm
Location: leeds ny

Re: New V8

Post by scubagli »

Now the high pressure power steering line is leaking...anyone have one I'd prefer a leaky one I can have rebuilt.
User avatar
scubagli
Posts: 604
Joined: Wed Feb 05, 2014 4:20 pm
Location: leeds ny

Re: New V8

Post by scubagli »

So I installed a chipped ecu, check engine light came on and is staying on. Tried to log in with vagcom but cannot connect. Any one else have issues like this? Car runs fine and feels faster. The tcu seems to have cleared the "parking lot bind"....
User avatar
scubagli
Posts: 604
Joined: Wed Feb 05, 2014 4:20 pm
Location: leeds ny

Re: New V8

Post by scubagli »

Finally found time to blink codes, got 2342 o2 signal voltage/bad o2 heater etc. That is brand new. 2141 excessive knock 2111 rpm sensor defective. Cleared codes and they came back as soon as I started the car. Stock ecu had no codes this one does, what gives is this chipped ecu messed up? Any suggestions?

Sent from my KFSOWI using Tapatalk
User avatar
PRY4SNO
Posts: 2430
Joined: Sun Mar 03, 2013 5:14 pm
Location: Edmonton, AB

Re: New V8

Post by PRY4SNO »

Can you swap the knock sensors for known good ones, just to rule that out?

IDK really, just throwing that out there to get the ball rolling.
Find me on Instagram @pry4sno

|| 2010 Golf Sportwagen TDI /// #farmenwagen
|| 2002 Dodge Ram 2500 24vt 4x4 #bertancummins
|| 1992 80 quattro 20v /// Eventual AAN'd Winter Sled
|| 1990 Coupe quattro /// Because Racecar
User avatar
scubagli
Posts: 604
Joined: Wed Feb 05, 2014 4:20 pm
Location: leeds ny

Re: New V8

Post by scubagli »

Yeah I might give that a shot, thanks.

Sent from my KFSOWI using Tapatalk
User avatar
pete82
Posts: 105
Joined: Mon Aug 05, 2013 9:42 pm

Re: New V8

Post by pete82 »

how'd you get on?

is the car silver or pearl white?
User avatar
scubagli
Posts: 604
Joined: Wed Feb 05, 2014 4:20 pm
Location: leeds ny

Re: New V8

Post by scubagli »

I haven't done anything...it's pearl.

Sent from my KFSOWI using Tapatalk
User avatar
pete82
Posts: 105
Joined: Mon Aug 05, 2013 9:42 pm

Re: New V8

Post by pete82 »

thanks, I wasn't sure on the color it was a bit hard to tell on my screen.

What plans do you have for the car and whats the engine/power? :)
User avatar
scubagli
Posts: 604
Joined: Wed Feb 05, 2014 4:20 pm
Location: leeds ny

Re: New V8

Post by scubagli »

For the time being it is just a daily, I'd very much like to manual swap it, and perhaps put in an s8 motor...it's hard to say I love driving it but it has a ton of small annoying issues, I will probably address them slowly. It's a pt 3.6, 247bhp, 251 ft lbs....
User avatar
AngryTaco
Posts: 2657
Joined: Sun Mar 03, 2013 11:38 pm
Location: Hayden Lake, Idaho

Re: New V8

Post by AngryTaco »

I love my 3.6L v8q :)

It has small issues too but hey...it's 24 years old, what do you expect
1986 4000cs Turbo Quattro
2001 Dodge Dakota R/T Standard Cab
1990 V8 quattro
1995 urS6

-Hersh Performance and Racing Products-
Most orders are being refused until further notice. Please PM

Powerflex Dealer

#thuglife
Post Reply