The Project Pad

Had to move this here to not get deleted from MG....
Chipsets being offered currently are:

20vt:
-3B w/ 2.5bar transducer upgrade, Stage III+ (around 277hp)
-AAN w/ stock transducer, Stage III (around 265hp)
-AAN w/ vMAP transducer, Stage III+ (around 277hp)

V8 Quattro:
-ECU repgrogramming to make it smoother and up to 10% gain

All chipsets are $300 (includes chipset, installation, and return shipping w/ $500 insurance), except V8 ($200 includes chipset, installation, and return shipping w/ $500 insurance) and AAN Stage III+ ($510 includes chipset, installation, and return shipping w/ $500 insurance).

"All the programming rams up the boost quickly and tapers it off toward red line (keeps the K24 from overspinning). The 3B tune runs 20 – 22 psi, The AAN Stage III (IIRC) is 18 psi (I should verify that) and the Stage III+ is 24 with an planned over-boost (if you pop the throttle quickly) to 26. Frankly, I tried to sell the Stage III+ to people because it was so much better. Over the years, I only sold a couple of Stage III’s. The MAC-11 Stage 1 was 12 psi)."

E-mail: roger.mozden@gmailDOTcom

Ha, I just PM'd you there to tell you to come here.

Not trying to be critical Roger but could you guys stabilize the prices? I was following the thread over on MG and they've jumped up several times in the past week.

2nd on stabilizing prices and what's included (return shipping, etc.)

Also, I'd post this in the member products section as long as it's ok, less threads to get lost in and more appropriate as "swap meet" to me is usually second hand.

Sorry. I just made it easier after talking with Justin. Did all the math so I just put the pricing with everything included, as before the prices were plus shipping. The $25 bump was to cover any costs that may come up if his old stock runs out. Pricing should be firm at this point unless pricing on VMAPs go up or something of that sort.

I'm looking for JUST the chips for a 551A ecu(s4 but I'm running it in an S6).
Stage IV/V. I've got Pastore RS2 set right now but it's a little ping-y.
I have RS2 Turbo, Manifold, MAF, Cam, Injectors(dekas, I think. I'll have to get the part number), Stromung Exhaust and I'm looking for a 93 tune.
Thanks,
Steve

Mac14?

Not yet. Checking on spring availability for the MAC14

rogermoz wrote:Not yet. Checking on spring availability for the MAC14

Im not worried about a spring. Just need the chip

He's unwilling to sell them just as a chipset as it make diagnosing problems really hard.

rogermoz wrote:He's unwilling to sell them just as a chipset as it make diagnosing problems really hard.

Ah well ill just conver to efi then

I would also be interested in JUST the chipset, no installation, no shipping, no VMAP.

FWIW, I took the 1.9bar spring I got from Ben Swann for my UrS4 chip and put it in my 20vt wastegate. Runs great with the Ben Swann 2+ superchip in my 5ktq. If IA has a source for the 20v springs they should work just fine in the 20v.

Yeah. Alex nixed the 20vt stuff since his supplier won't sell springs in less than 500 per lot at a time.

I'm looking to get a chip for the urs4. My buddy has a intended acceleration stage 3 ecu I can get. What do you guys think yay or nay? My car is 100% stock. He says it takes the boost to 25 and taper to 22ish.

Do you still have these ?