Page 1 of 1
60-2 rear crank seal
Posted: Sun Jan 12, 2014 8:39 pm
by gtn116
60-2 rear crank seal, installed on a motor with the plug cut off (to go out a hole in the bellhousing). The kit is $275 from Marc. I want $250 OBO. Also have an ABY intercooler with some pipes welded on it. Make an offer on it.
Re: Ghetto 20vt, VEMS and harness
Posted: Tue Jan 14, 2014 7:59 pm
by AngryTaco
Would you considering selling just the VEMS?
Re: Ghetto 20vt, VEMS and harness
Posted: Tue Jan 14, 2014 8:02 pm
by chaloux
AngryTaco wrote:Would you considering selling just the VEMS?
AND SO IT BEGINS!
Re: Ghetto 20vt, VEMS and harness
Posted: Tue Jan 14, 2014 8:10 pm
by gtn116
You were just the guy I was hoping to rope in. ;-) I would prefer to get rid of the vems, harness and rear crank seal/trigger wheel together because they're pretty useless without each other.
Re: Ghetto 20vt, VEMS and harness
Posted: Wed Jan 15, 2014 12:57 am
by AngryTaco
chaloux wrote:AngryTaco wrote:Would you considering selling just the VEMS?
AND SO IT BEGINS!
Why does all the good stuff pop up when I'm spending $300 on a damn rollpan for my Dodge this week!?
Anyways PM sent to OP