The Project Pad

I need the following in good usable condition. Thanks.

clutch fork


clutch fork pivot


hold down clip shown held in place with torx bolt

i should have something layin around with all the damned 01Es i take apart. remind me later tonight.

with 6 trans's and only use two at a time, i gotta have somethin.

i will send you a reminder PM this evening. Thanks.

Hey Aaron, or anyone else, have you ever seen different 01E forks for the release bearing? My old clutch that worked flawless on my setup isn't working on the new owner. It almost seems like his fork is deeper than mine was. I have no clue where my fork came from as I bought it separate from someone on here so we have been having a hard time sorting this out.

Sorry to hijack this post but it may actually be relevant

Not me all the ones I have are or appear to be the same



Sent from my SCH-I545 using Tapatalk

Thanks Aaron

great question jim, i assumed all 01e's were the same.

I think everyone does. Just make sure you test clutch action before you bolt everything back together. Hank dug up a pic of two that were different, but neither helped the situation. It could be a failing master too for our problem.