Aluminum Mounting Plates for Epic Motor Mounts Limited Offer
Posted: Mon Aug 03, 2015 8:53 pm
Looks like I will have some new equipment this week. I will finally be picking up a TIG welder in order to start doing new designs and products.
I am going to be offering a limited run of Aluminum Motor Mount plates for the 5-cyl and V8q cars (Early 80s till 1995.5). This is going to help offset my initial purchase of the TIG
At this point in time, I have no plans to offer these again except during special offerings at a higher price.
If you already have a set of mounts with the steel plates, your cost will be $100 for plates ONLY.
If you want an entire kit with poly, etc, your cost will be $200.
Add $15 for shipping EXCEPT for international and cananadian residents.
I am offering 25 pairs (50 total mounts). If demand is high enough, I will up that. Share and notify your fellow audi freaks
I am going to be offering a limited run of Aluminum Motor Mount plates for the 5-cyl and V8q cars (Early 80s till 1995.5). This is going to help offset my initial purchase of the TIG
At this point in time, I have no plans to offer these again except during special offerings at a higher price.
If you already have a set of mounts with the steel plates, your cost will be $100 for plates ONLY.
If you want an entire kit with poly, etc, your cost will be $200.
Add $15 for shipping EXCEPT for international and cananadian residents.
I am offering 25 pairs (50 total mounts). If demand is high enough, I will up that. Share and notify your fellow audi freaks