The Project Pad

I picked this up some time ago, to use on my 20vt project. I have decided to build a long tube header and go hy35. So its up for sale.

This turbo consists of a Porsche K26/6 turbine and exhaust housing, Audi K26 center, and turbonetics t04b compressor wheel and housing. It has had a fresh rebuild, and also balanced at GPop. It has never been installed. This should be a nice upgrade for any 20vt or 20vt. It it was built to be a direct bolt on, using the factory oil and coolant lines.




k26 on left, t04b on right



Here is the rotating assembly before being sent off for balance. I also opted to use the Audi K26 compressor dual seal ring collar.



I'm asking $500 plus shipping.

Thanks for looking

I'm very interested! How much hp do you believe it makes?

PM sent as well

Its tough to judge, as this hybrid is normally found being used on Porsche 944's. I was personally hoping for around 300hp on my 20vt setup. Obviously every setup is different though. On a 20vt, I have no clue.

Chp I take it?

88a5tq wrote:Chp I take it?

Yes. From what I can tell, it should be similar to the Volvo K24. I have no solid proof of this though.

Sale pending.

Woop woop