K26-6 Holset HX35 Turbine Housing + STR Log Manifold

[Ruyck]

Anybody have any interest in a K26/6 exhaust housing machined to fit a Holset HX35? I put maybe 500 miles on this setup and made 320/310 at the wheels on 91 and a conservative tune. It's a little too much compressor for the small hot side but it was a blast. I found a deal on a T3 Wagner manifold so this came out and a .63 T3 went in.

Cost me ~$450 in parts, machine tools, and labor. I'm not sure if there's any interest but if I have to put a price on it, how about $300 shipped? Trying to fund a move back east and lean up some of my parts pile.
I still have the STR KKK log manifold pictured. I picked it up a few years ago but it's still in great shape. $150 shipped.
I've also got the old 3B engine harness from when my 4000 was still running stock engine management. $100 shipped. Message for pictures and details.

Mounted:

K26/HX35 Mounted To STR Manifold

20150112_160512.jpg (2.63 MiB) Viewed 5060 times

Compared to stock K24:

K24 vs Machined K26

20141202_193053.jpg (3.24 MiB) Viewed 5060 times

Machined K26

20141202_193226.jpg (2.75 MiB) Viewed 5060 times

Theres some hairline cracks as shown in the pictures below. I don't know if they were there when I purchased it or post machine but it doesn't seem to.

Machined K26-6 Cracks

20141202_193235.jpg (1.86 MiB) Viewed 5060 times

[Ruyck]

STR manifold is spoken for.